Reconyx Hyperfire Manual de Instruções descarregar pdf (Página 10)

9 ©RECONYX, Inc.

Secure Digital

(SD or SDHC) Card Specifications

A Secure Digital (SD/SDHC) card is used to store the pictures your camera

captures. These images may be transferred to your computer using standard

image viewing software or RECONYX™ MapView™ or BuckView™ mapping

and image management software.

TIP: Many digital cameras, GPS units, and cell phones can be used to view

images taken by your HyperFire™ camera. No need to purchase a special

purpose viewer!

Inserting and Removing the memory card

Make sure the orientation is correct and that the card is aligned properly.

Push gently on the memory card as shown below until it clicks into place.

Warning: Inserting the memory card upside down or backwards could

damage the camera or the memory card. Damage resulting from inserting

the card incorrectly is not covered under warranty.

To remove memory cards:

1. Press <OK> to disarm the camera (the battery status and number of

pictures taken since last armed will be displayed on the LCD).

2. Switch the power OFF.

3. Press and release the card to partially eject the memory card.

4. The card can then be removed by grasping it with your fingers.

NOTE: Always disarm the camera (by pressing OK) and switch the power off

before removing or inserting the memory card.

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 31 32

Sem comentários

Reconyx Hyperfire Manual de Instruções Página 10