Reconyx Hyperfire Manual de Instruções descarregar pdf (Página 16)

15 ©RECONYX, Inc.

Level 2: Quickset Options

NOTE: “Quickset Options” are shown in Blue on the “Programming Diagram”

(Page 13).

When Change Setup is selected the QuickSet options are displayed

(NORMAL/TRAIL, Aggressive/Scrape, Conservative/Feeder, and Advanced).

This allows you to quickly select pre-programmed settings that are optimized for

particular situations. Selecting “Advanced” takes you to the settings listed below.

Professional

Series

Outdoor

Series

Pictures per

Trigger

Picture

Interval

Quiet

Period

NORMAL

TRAIL

3 pictures

1 second

None

Aggressive

Scrape

5 pictures

RapidFire™

None

Conservative

Feeder

3 pictures

5 seconds

15 secs

Level 3: Advanced Settings

NOTE: “Advanced Settings” are shown in Grey on the “Programming Diagram”

(Page 13).

Trigger – Turn your camera’s motion sensor on or off, select the sensitivity level

of the PIR motion detector, set how many photos you want your camera to take

per trigger, the interval between pictures, and the quiet period (the time period

after a trigger during which the camera will not respond to motion events).

1. Motion Sensor – ON, off

2. Sensitivity - low, low/medium, medium, medium/high, HIGH.

3. Pictures Per Trigger – 1, 2, 3, 5, or 10

4. Picture Interval – RapidFire™, 1 SEC, 3 sec, 5 sec, or 10 sec

5. Quiet Period – NO DELAY, 15 sec, 30 sec, 1 min, 3 min or 5 min

Time Lapse – To control your camera’s time lapse photography, select the

starting and ending times, and the interval between pictures taken.

1 2 ... 11 12 13 14 15 16 17 18 19 20 21 ... 31 32

Comentários a estes Manuais

Sem comentários

Reconyx Hyperfire Manual de Instruções Página 16

Comentários a estes Manuais

Manuais e produtos relacionados com Câmaras de segurança Reconyx Hyperfire